Network expert of industrial IOT
sales@usriot.com
PUSR Cloud Official Website
PUSR Cloud Official Website
Leave Message

*

*

*

*

*

*

*

Support Center

USR IOT SERVICE AND SUPPORT

Industrial Serial to Ethernet Converters
Home-FAQ-Industrial Serial to Ethernet Converters
Home/FAQ/Industrial Serial to Ethernet Converters

Data Transmission Test of serial to Ethernet converter USR-N540

Data Transmission Test of serial to Ethernet converter USR-N540

2020-05-11

2020-05-11
Share TO:

This article is about the data transmission test of serial to Ethernet converter USR-N540. Data transmission test is based on the default parameters, please refer to the following steps:

 

 

1. Open test software “USR-TCP232-Test.exe”, and do hardware connection according to Chapter 1.1 Hardware Testing Environment.

 

2. The right side is Network Settings: TCP Client, IP address: 192.168.0.7, port number: 23, click “Connect” to build TCP connection.

The left side is Serial Settings: Baud Rate: 115200, Parity/Data bit/Stop bit: None/8/1,

Click “Open” to enable the COM.

Then we can test data transmission between COM and network.

Data from serial to network is: PC’ COM->USR-N540’ COM->USR-N540 Ethernet port->PC Network;

Data from network to serial is: PC Network->N540’ Ethernet port->N540 COM-> PC’s COM.

 

The below picture is about the data transmission test of serial to Ethernet converter USR-N540  for your reference:

default parameter test