Products
Product Classification
Data download
Support Center
Data Transmission Test of serial to Ethernet converter USR-N540
2020-05-11

This article is about the data transmission test of serial to Ethernet converter USR-N540. Data transmission test is based on the default parameters, please refer to the following steps:

 

 

1. Open test software “USR-TCP232-Test.exe”, and do hardware connection according to Chapter 1.1 Hardware Testing Environment.

 

2. The right side is Network Settings: TCP Client, IP address: 192.168.0.7, port number: 23, click “Connect” to build TCP connection.

The left side is Serial Settings: Baud Rate: 115200, Parity/Data bit/Stop bit: None/8/1,

Click “Open” to enable the COM.

Then we can test data transmission between COM and network.

Data from serial to network is: PC’ COM->USR-N540’ COM->USR-N540 Ethernet port->PC Network;

Data from network to serial is: PC Network->N540’ Ethernet port->N540 COM-> PC’s COM.

 

The below picture is about the data transmission test of serial to Ethernet converter USR-N540  for your reference:

default parameter test

 

Don't hesitate to contact PUSR.
Reliable products and services around you!
Subscribe Email
Ethernet Modules
WiFi Modules
4G Modules
Bluetooth Module
Contact Us
Email : inquiry@usriot.com
Tel : +86-531-88826739
Fax : +86-531-88826739-808
Address : Floor 12 and 13, CEIBS
of Maolingshan, Lixia District, Jinan,
Shandong, China
Copyright © Jinan USR IOT Technology Limited All Rights Reserved. Tags   /  Sitemap   /  Privacy Policy