Products
Product Classification
Data download
Support Center
How to Enter AT Command Mode - USR-TCP232-E2
2020-08-13

1. Open AT Setup software, set the serial parameters of USR-TCP232-E2, then click “Open ”. Send “+++a” from the serial port, then “a+ok” will be returned. After setting the parameters, send “AT+Z” to restart the device.

AT setup software download address:

http://www.pusr.com/download/WIFI/USR-WIFI-AT%20Command%20Software.zip

AT setup software


2. Or we can send AT commands with other serial software: USR-TCP232-Test download address:

http://www.pusr.com/download/software/USR-TCP232-Test%20V1.4.exe

Open the serial port, send “+++”(Without line breaks) from the serial port, then will receive the "a" returned by the device. Reply an "a" to the device within 3S, and will receive "+ok" , which indicates that the device has entered AT command mode.

USR-TCP232-Tester

USR-TCP232-Tester

Send AT command (with a line break) from the serial port to query or set the parameters of USR-TCP232-E2.

Send “AT+ENTM” to exit AT command mode.

Note: In serial software, all the AT commands should be sent with a line break.

USR-TCP232-Tester

 

3. AT command set download address:

http://www.pusr.com/Support/download_hits.html?id=145

 

Don't hesitate to contact PUSR.
Reliable products and services around you!
Subscribe Email
Ethernet Modules
WiFi Modules
4G Modules
Bluetooth Module
Contact Us
Email : inquiry@usriot.com
Tel : +86-531-88826739
Fax : +86-531-88826739-808
Address : Floor 12 and 13, CEIBS
of Maolingshan, Lixia District, Jinan,
Shandong, China
Copyright © Jinan USR IOT Technology Limited All Rights Reserved. Tags   /  Sitemap   /  Privacy Policy