Products
Product Classification
Data download
Support Center
Default Parameter Test of 8 Ports Serial to Ethernet Converter USR-N668
2020-05-11

Default Parameter Test of 8 Ports Serial to Ethernet Converter USR-N668

 

Default parameter of 8-port serial to ethernet converter

 

After confirmation

You can carry out the bidirectional between the serial port and the Ethernet port.
Communication procedures are as follows:
1) Open the testing software” USR TCP232 Test.exe ””,connected hardware
2) The default mode of operation is TCP Server, f irst port serial port monitor 20001 port So choose TCP client mode at the network setup end of the software ,IP:192.168.0.7,target port 20001,then click the connect. The serial baud
rate is 115200, The serial port parameter is set to None/8/1,chick open.
3) Send data for test, the data flow form serial port to Net is: PC serial port -->668 serial port -->668 Ethernet port -->PC
network; the data flow form Net to serial port is: PC network -->668 Ethernet port -->668 serial port -->PC serial p ort.
The specific demo is shown below.
 
data transmission test
data transmission test of serial to ethernet converter
 
 
The USR
TCP232 Test.exe d ownload links
https://www.usriot.com/support/downloads/usr tcp test testing software.html

 

Don't hesitate to contact PUSR.
Reliable products and services around you!
Subscribe Email
Ethernet Modules
WiFi Modules
4G Modules
Bluetooth Module
Contact Us
Email : inquiry@usriot.com
Tel : +86-531-88826739
Fax : +86-531-88826739-808
Address : Floor 12 and 13, CEIBS
of Maolingshan, Lixia District, Jinan,
Shandong, China
Copyright © Jinan USR IOT Technology Limited All Rights Reserved. Tags   /  Sitemap   /  Privacy Policy /  Back to previous version