Ethernet to RS232/422/485 Serial Converter USR-N510
1. Hardware Installation
Use a standard Ethernet cable to connect the USR- N510 to an Ethernet router or connect it directly to a PC.
RS-232/422/485 can connect with a PC or other serial port device by serial cables.
2.Serial Port
RS-232 DB9 Male Port RS-485/422 Terminal header ( Will provide connector)
|
DB9 PIN |
RS-232 | RS-422 |
RS-485 Half Duplex |
| 1 | |||
| 2 | RXD | RX+ | |
| 3 | TXD | TX- | Data- |
| 4 | |||
| 5 | Ground | ||
| 6 | |||
| 7 | RTS | TX+ | Data+ |
| 8 | CTS | RX- | |
| 9 | |||
Flexible shift among rs232,485 and 422
3. Software Installation
Download Setup/Test program from website
Install Virtual COM software- VCOM https://www.usriot.com/p/rs232rs485rs422-serial-ethernet- converter/ Note: Be sure you have administrative rights and disable any firewalls/anti-virus software when install software.
Note: Be sure you have administrative rights and disable any firewalls/anti-virus software when install software.
4. Configure USR-N510
Assign a static IP address to your computer in the 192.168.0.2 to 192.168.0.254 range. Mask 255.255.255.0. This is necessary to ensure that your computer can communicate with your USR-N510.
The default IP address of USR-N510 is 192.168.0.7 Open your web browser and enter this IP to connect to USR-N510 for configure.
| Default Parameters | |
| User Name | admin |
| Password | admin |
| IP address | 192.168.0.7 |
| Mask | 255.255.255.0 |
| Gateway | 192.168.0.1 |
| Work Mode | TCP Server |
| Local Port | 8899 |
| Baud Rate | 115200 |
| Parity bit/Data bit/Stop bit | None/8/1 |
5.Product Display
